Spectra-precision Survey Pro v4.5 Ranger User Manual Manuel d'utilisateur télécharger pdf (Page 277)

GPS Module

267

4. Enter the distance from the GPS reference point to the offset

point. You can enter the distance by hand or you can get it from

the selected conventional instrument by tapping Shoot Laser.

Note: You have to switch to conventional mode to configure the laser

range finder or total station.

5. Enter the direction (azimuth/bearing) from the reference point to

the offset point. You can enter a direction in one of the following

ways:

• Using the horizontal angle returned from the conventional

instrument if you took a shot.

• Occupying a point on line with the reference point and the

offset point. After you occupy the reference point, tap

Direction from Two Points and then occupy a point on line with

the reference point and the offset point. When you are done

occupying the on line point, you will be prompted for the

direction to your offset point.

• Entering a value by hand, such as when you measure the

offset direction with a compass.

6. Tap Store to store the offset point.

7. Store any number of additional offset points from this GPS

reference point. The shot data for each point is recorded in .RAW

data. Tap Close when you are done storing points.

1 2 ... 272 273 274 275 276 277 278 279 280 281 282 ... 338 339

Pas de commentaire

Spectra-precision Survey Pro v4.5 Ranger User Manual Manuel d'utilisateur Page 277