Spectra-precision Survey Pro v4.5 Ranger User Manual Manuel d'utilisateur télécharger pdf (Page 144)

User’s Manual – Conventional Mode

134

Slope Staking in Remote Mode

Slope staking in remote control mode functions in nearly the same

way as with a non-remote total station (see Page 138). The one

difference is when using the final Slope Staking

screen, where the

catch point is being located, the graphic portion of the Horizontal Map

and Vertical Map is updated continuously. This allows the user at the

rod position to watch the movement of the prism in relation to the

slope and easily position the rod over the catch point.

Note: You can tap in the graphic portion of the screen to open the

graphic in a larger window.

Although the graphic portion of the screen is continuously updated,

the numeric values are not updated until the Shot button is tapped.

This is because accurately locating the catch point depends on

measuring an accurate elevation at the rod position. When the rod is

moving, there is no way to estimate how far the rod is lifted off the

ground. Therefore, the correct procedure for slope staking in remote

mode is to use the graphic portion of the screen to locate the catch

point as closely as possible, position the rod on the ground and press

Shot. Once the values are updated, you can determine if the rod

needs to be moved again.

Remote staking between 1 and 10 feet

Remote staking over target

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 338 339

Pas de commentaire

Spectra-precision Survey Pro v4.5 Ranger User Manual Manuel d'utilisateur Page 144