Spectra-precision Layout Pro Field Software Quick Start Guide Manuel d'utilisateur télécharger pdf (Page 30)

• Tap Next.

• Select the point from the plan where to set up the

instrument ([1]). Set up the instrument at this

location.

• Tell Layout Pro whether you want to measure elevation

(Yes/No) then tap Next. If you are setting up on a known

point and you want to measure elevation, first enter the

instrument height, then tap Next.

• Select the reference point from the plan ([2]). Have a

target placed over this point.

• Check that everything is ready for a shot ([3]), aim the

instrument at the target and then tap Shoot.

• After Layout Pro has reported a valid measurement

([4]), tap Finish. Station setup is now complete.

NOTE: If there is only one point stored in the plan,

then Layout Pro will assume this point (with known

coordinates) is occupied by the instrument, and will

prompt you, from this point, to shoot a reference point

with unknown coordinates.

[1] [2]

[3] [4]

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Pas de commentaire

Spectra-precision Layout Pro Field Software Quick Start Guide Manuel d'utilisateur Page 30